Computer Interfacing
Discussions about interfacing and electronics

Help with pin wiring / ID

Pin ID


       Computer Interfacing Forum Index -> General serial
Author Message

Aug 13, 2014 6:59 pm

Hi, I have a foreign product that has very little information along with it. This program runs on a standard windows computer and connects to a specialized industrial type controller. The program opens and runs fine on the computer, however to connect it to the 9 pin female terminal on the controller these are the only instructions given:


I'm believe that the numbers ref pin numbers on the male terminal I should connect to the controller, but I don't know what the original configuration of the 9 pin on a standard computer are to know what to do on the computer side?

Sorry, for my confusion.....I know just enough o get me in trouble, but not enough to know what to do here. Any help would be greatly appreciated.

       Computer Interfacing Forum Index -> General serial
Page 1 of 1

Running on php BB © 2001, 2009 php BB Group
   Lammert Bies     Interfacing     Sitemap     Forum