Computer Interfacing
Discussions about interfacing and electronics
 

Setting up a keystroke interface

Need help on sending Keystrokes


 

       Computer Interfacing Forum Index -> General talk
Author Message
Guest








Jan 22, 2008 11:22 pm

Hello,
I know this is a long shot! but I been wondering about this for a long while! I would like to setup a interface that will sent KeyStrokes to a computer using the PS/2 port but I would like to do this though a serial port or a USB port. In other words I will have a live computer running and senting keystrokes to another computer though the serial port or USB port. Can this be done? and if so? what kind of software would I have to used to make this happen? Let me know if anyone can help me out?
Thank You
spyerpwd
spyerpwd
New User



Joined: 22 Jan 2008
Posts: 1


Jan 22, 2008 11:24 pm

Hello,
Sorry I didn't login but the posting above is from me! (spyerpwd)
Thank You
samuelarnold
Junior Member



Joined: 28 Mar 2011
Posts: 20


Mar 28, 2011 11:25 am

If you own a common card, most of the time you will not have to look very hard for a driver. Drivers for common network cards are present in the GENERIC kernel, so your card should show up during boot, like so:

dc0: <82c169 PNIC 10/100BaseTX> port 0xa000-0xa0ff mem 0xd3800000-0xd38
000ff irq 15 at device 11.0 on pci0
miibus0: <MII bus> on dc0
bmtphy0: <BCM5201 10/100baseTX PHY> PHY 1 on miibus0
bmtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
dc0: Ethernet address: 00:a0:cc:da:da:da
dc0: [ITHREAD]
dc1: <82c169 PNIC 10/100BaseTX> port 0x9800-0x98ff mem 0xd3000000-0xd30
000ff irq 11 at device 12.0 on pci0
miibus1: <MII bus> on dc1
bmtphy1: <BCM5201 10/100baseTX PHY> PHY 1 on miibus1
bmtphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
dc1: Ethernet address: 00:a0:cc:da:da:db
dc1: [ITHREAD]

       Computer Interfacing Forum Index -> General talk
Page 1 of 1



Running on php BB © 2001, 2009 php BB Group
   Lammert Bies     Interfacing     Sitemap     Forum